/* * CDDL HEADER START * * The contents of this file are subject to the terms of the * Common Development and Distribution License (the "License"). * You may not use this file except in compliance with the License. * * You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE * or http://www.opensolaris.org/os/licensing. * See the License for the specific language governing permissions * and limitations under the License. * * When distributing Covered Code, include this CDDL HEADER in each * file and include the License file at usr/src/OPENSOLARIS.LICENSE. * If applicable, add the following below this CDDL HEADER, with the * fields enclosed by brackets "[]" replaced with your own identifying * information: Portions Copyright [yyyy] [name of copyright owner] * * CDDL HEADER END */ /* * Copyright(c) 2007-2010 Intel Corporation. All rights reserved. */ /* * Copyright (c) 2008, 2010, Oracle and/or its affiliates. All rights reserved. */ /* IntelVersion: 1.81 v3_3_14_3_BHSW1 */ #ifndef _IGB_PHY_H #define _IGB_PHY_H #ifdef __cplusplus extern "C" { #endif void e1000_init_phy_ops_generic(struct e1000_hw *hw); s32 e1000_null_read_reg(struct e1000_hw *hw, u32 offset, u16 *data); void e1000_null_phy_generic(struct e1000_hw *hw); s32 e1000_null_lplu_state(struct e1000_hw *hw, bool active); s32 e1000_null_write_reg(struct e1000_hw *hw, u32 offset, u16 data); s32 e1000_check_downshift_generic(struct e1000_hw *hw); s32 e1000_check_polarity_m88(struct e1000_hw *hw); s32 e1000_check_polarity_igp(struct e1000_hw *hw); s32 e1000_check_polarity_ife(struct e1000_hw *hw); s32 e1000_check_reset_block_generic(struct e1000_hw *hw); s32 e1000_copper_link_setup_igp(struct e1000_hw *hw); s32 e1000_copper_link_setup_m88(struct e1000_hw *hw); s32 e1000_phy_force_speed_duplex_igp(struct e1000_hw *hw); s32 e1000_phy_force_speed_duplex_m88(struct e1000_hw *hw); s32 e1000_phy_force_speed_duplex_ife(struct e1000_hw *hw); s32 e1000_get_cable_length_m88(struct e1000_hw *hw); s32 e1000_get_cable_length_igp_2(struct e1000_hw *hw); s32 e1000_get_cfg_done_generic(struct e1000_hw *hw); s32 e1000_get_phy_id(struct e1000_hw *hw); s32 e1000_get_phy_info_igp(struct e1000_hw *hw); s32 e1000_get_phy_info_m88(struct e1000_hw *hw); s32 e1000_phy_sw_reset_generic(struct e1000_hw *hw); void e1000_phy_force_speed_duplex_setup(struct e1000_hw *hw, u16 *phy_ctrl); s32 e1000_phy_hw_reset_generic(struct e1000_hw *hw); s32 e1000_phy_reset_dsp_generic(struct e1000_hw *hw); s32 e1000_read_kmrn_reg_generic(struct e1000_hw *hw, u32 offset, u16 *data); s32 e1000_read_kmrn_reg_locked(struct e1000_hw *hw, u32 offset, u16 *data); s32 e1000_read_phy_reg_igp(struct e1000_hw *hw, u32 offset, u16 *data); s32 e1000_read_phy_reg_igp_locked(struct e1000_hw *hw, u32 offset, u16 *data); s32 e1000_read_phy_reg_m88(struct e1000_hw *hw, u32 offset, u16 *data); s32 e1000_set_d3_lplu_state_generic(struct e1000_hw *hw, bool active); s32 e1000_setup_copper_link_generic(struct e1000_hw *hw); s32 e1000_wait_autoneg_generic(struct e1000_hw *hw); s32 e1000_write_kmrn_reg_generic(struct e1000_hw *hw, u32 offset, u16 data); s32 e1000_write_kmrn_reg_locked(struct e1000_hw *hw, u32 offset, u16 data); s32 e1000_write_phy_reg_igp(struct e1000_hw *hw, u32 offset, u16 data); s32 e1000_write_phy_reg_igp_locked(struct e1000_hw *hw, u32 offset, u16 data); s32 e1000_write_phy_reg_m88(struct e1000_hw *hw, u32 offset, u16 data); s32 e1000_phy_reset_dsp(struct e1000_hw *hw); s32 e1000_phy_has_link_generic(struct e1000_hw *hw, u32 iterations, u32 usec_interval, bool *success); s32 e1000_phy_init_script_igp3(struct e1000_hw *hw); enum e1000_phy_type e1000_get_phy_type_from_id(u32 phy_id); s32 e1000_determine_phy_address(struct e1000_hw *hw); void e1000_power_up_phy_copper(struct e1000_hw *hw); void e1000_power_down_phy_copper(struct e1000_hw *hw); s32 e1000_read_phy_reg_mdic(struct e1000_hw *hw, u32 offset, u16 *data); s32 e1000_write_phy_reg_mdic(struct e1000_hw *hw, u32 offset, u16 data); s32 e1000_read_phy_reg_i2c(struct e1000_hw *hw, u32 offset, u16 *data); s32 e1000_write_phy_reg_i2c(struct e1000_hw *hw, u32 offset, u16 data); s32 e1000_copper_link_setup_82577(struct e1000_hw *hw); s32 e1000_check_polarity_82577(struct e1000_hw *hw); s32 e1000_get_phy_info_82577(struct e1000_hw *hw); s32 e1000_phy_force_speed_duplex_82577(struct e1000_hw *hw); s32 e1000_get_cable_length_82577(struct e1000_hw *hw); #define E1000_MAX_PHY_ADDR 4 /* IGP01E1000 Specific Registers */ #define IGP01E1000_PHY_PORT_CONFIG 0x10 /* Port Config */ #define IGP01E1000_PHY_PORT_STATUS 0x11 /* Status */ #define IGP01E1000_PHY_PORT_CTRL 0x12 /* Control */ #define IGP01E1000_PHY_LINK_HEALTH 0x13 /* PHY Link Health */ #define IGP01E1000_GMII_FIFO 0x14 /* GMII FIFO */ #define IGP01E1000_PHY_CHANNEL_QUALITY 0x15 /* PHY Channel Quality */ #define IGP02E1000_PHY_POWER_MGMT 0x19 /* Power Management */ #define IGP01E1000_PHY_PAGE_SELECT 0x1F /* Page Select */ #define BM_PHY_PAGE_SELECT 22 /* Page Select for BM */ #define IGP_PAGE_SHIFT 5 #define PHY_REG_MASK 0x1F #define HV_INTC_FC_PAGE_START 768 #define I82578_ADDR_REG 29 #define I82577_ADDR_REG 16 #define I82577_CFG_REG 22 #define I82577_CFG_ASSERT_CRS_ON_TX (1 << 15) #define I82577_CFG_ENABLE_DOWNSHIFT (3 << 10) /* auto downshift 100/10 */ #define I82577_CTRL_REG 23 /* 82577 specific PHY registers */ #define I82577_PHY_CTRL_2 18 #define I82577_PHY_LBK_CTRL 19 #define I82577_PHY_STATUS_2 26 #define I82577_PHY_DIAG_STATUS 31 /* I82577 PHY Status 2 */ #define I82577_PHY_STATUS2_REV_POLARITY 0x0400 #define I82577_PHY_STATUS2_MDIX 0x0800 #define I82577_PHY_STATUS2_SPEED_MASK 0x0300 #define I82577_PHY_STATUS2_SPEED_1000MBPS 0x0200 #define I82577_PHY_STATUS2_SPEED_100MBPS 0x0100 /* I82577 PHY Control 2 */ #define I82577_PHY_CTRL2_AUTO_MDIX 0x0400 #define I82577_PHY_CTRL2_FORCE_MDI_MDIX 0x0200 /* I82577 PHY Diagnostics Status */ #define I82577_DSTATUS_CABLE_LENGTH 0x03FC #define I82577_DSTATUS_CABLE_LENGTH_SHIFT 2 #define IGP01E1000_PHY_PCS_INIT_REG 0x00B4 #define IGP01E1000_PHY_POLARITY_MASK 0x0078 #define IGP01E1000_PSCR_AUTO_MDIX 0x1000 #define IGP01E1000_PSCR_FORCE_MDI_MDIX 0x2000 /* 0=MDI, 1=MDIX */ #define IGP01E1000_PSCFR_SMART_SPEED 0x0080 /* Enable flexible speed on link-up */ #define IGP01E1000_GMII_FLEX_SPD 0x0010 #define IGP01E1000_GMII_SPD 0x0020 /* Enable SPD */ #define IGP02E1000_PM_SPD 0x0001 /* Smart Power Down */ #define IGP02E1000_PM_D0_LPLU 0x0002 /* For D0a states */ #define IGP02E1000_PM_D3_LPLU 0x0004 /* For all other states */ #define IGP01E1000_PLHR_SS_DOWNGRADE 0x8000 #define IGP01E1000_PSSR_POLARITY_REVERSED 0x0002 #define IGP01E1000_PSSR_MDIX 0x0800 #define IGP01E1000_PSSR_SPEED_MASK 0xC000 #define IGP01E1000_PSSR_SPEED_1000MBPS 0xC000 #define IGP02E1000_PHY_CHANNEL_NUM 4 #define IGP02E1000_PHY_AGC_A 0x11B1 #define IGP02E1000_PHY_AGC_B 0x12B1 #define IGP02E1000_PHY_AGC_C 0x14B1 #define IGP02E1000_PHY_AGC_D 0x18B1 #define IGP02E1000_AGC_LENGTH_SHIFT 9 /* Course - 15:13, Fine - 12:9 */ #define IGP02E1000_AGC_LENGTH_MASK 0x7F #define IGP02E1000_AGC_RANGE 15 #define IGP03E1000_PHY_MISC_CTRL 0x1B #define IGP03E1000_PHY_MISC_DUPLEX_MANUAL_SET 0x1000 /* Manually Set Duplex */ #define E1000_CABLE_LENGTH_UNDEFINED 0xFF #define E1000_KMRNCTRLSTA_OFFSET 0x001F0000 #define E1000_KMRNCTRLSTA_OFFSET_SHIFT 16 #define E1000_KMRNCTRLSTA_REN 0x00200000 #define E1000_KMRNCTRLSTA_DIAG_OFFSET 0x3 /* Kumeran Diagnostic */ #define E1000_KMRNCTRLSTA_TIMEOUTS 0x4 /* Kumeran Timeouts */ #define E1000_KMRNCTRLSTA_INBAND_PARAM 0x9 /* Kumeran InBand Parameters */ #define E1000_KMRNCTRLSTA_DIAG_NELPBK 0x1000 /* Nearend Loopback mode */ #define IFE_PHY_EXTENDED_STATUS_CONTROL 0x10 #define IFE_PHY_SPECIAL_CONTROL 0x11 /* 100BaseTx PHY Special Control */ #define IFE_PHY_SPECIAL_CONTROL_LED 0x1B /* PHY Special and LED Control */ #define IFE_PHY_MDIX_CONTROL 0x1C /* MDI/MDI-X Control */ /* IFE PHY Extended Status Control */ #define IFE_PESC_POLARITY_REVERSED 0x0100 /* IFE PHY Special Control */ #define IFE_PSC_AUTO_POLARITY_DISABLE 0x0010 #define IFE_PSC_FORCE_POLARITY 0x0020 #define IFE_PSC_DISABLE_DYNAMIC_POWER_DOWN 0x0100 /* IFE PHY Special Control and LED Control */ #define IFE_PSCL_PROBE_MODE 0x0020 #define IFE_PSCL_PROBE_LEDS_OFF 0x0006 /* Force LEDs 0 and 2 off */ #define IFE_PSCL_PROBE_LEDS_ON 0x0007 /* Force LEDs 0 and 2 on */ /* IFE PHY MDIX Control */ #define IFE_PMC_MDIX_STATUS 0x0020 /* 1=MDI-X, 0=MDI */ #define IFE_PMC_FORCE_MDIX 0x0040 /* 1=force MDI-X, 0=force MDI */ #define IFE_PMC_AUTO_MDIX 0x0080 /* 1=enable auto MDI/MDI-X, 0=disable */ #ifdef __cplusplus } #endif #endif /* _IGB_PHY_H */