# $NetBSD: Makefile,v 1.48 2008/05/25 21:42:20 joerg Exp $ # DISTNAME= qcad-2.0.5.0-1-community.src # what to do about this numbering? RibbonSoft really seems to use four digits # (there's a 2.0.4.7 for some platforms), though I don't know about the # thing after the hyphen, which always seems to be 1. Can I use four digits? PKGNAME= qcad-2.0.5.0 PKG_DESTDIR_SUPPORT= user-destdir .include "./Makefile.common" COMMENT= 2D CAD system GNU_CONFIGURE= yes USE_TOOLS+= autoconf gmake pax USE_LANGUAGES= c c++ CONFIGURE_DIRS= fparser dxflib BUILD_DIRS= ${CONFIGURE_DIRS} BUILD_DIRS+= qcadlib qcadcmd qcadactions qcadguiqt qcad MAKE_ENV+= QMAKESPEC=${QTDIR}/mkspecs/default PREPEND_PATH+= ${QTDIR}/bin # I really want this to be post-*patch* where it makes sense, but QTDIR isn't # available until after the wrapper phase because it depends on # BUILDLINK_PREFIX.qt3-libs, which buildlink3 sets. Nothing is easy. :) The # patches have replaced old hardcoded paths with fixed cookies @PREFIX@ and # @QTDIR@. The SUBST framework will replace the cookies with the proper # values. SUBST_CLASSES+= paths SUBST_STAGE.paths= pre-configure SUBST_MESSAGE.paths= Attending to hard-coded paths. SUBST_FILES.paths+= qcadlib/src/engine/rs_system.cpp SUBST_FILES.paths+= qcad/src/qc_applicationwindow.cpp SUBST_SED.paths= -e 's,@PREFIX@,${PREFIX},g' SUBST_SED.paths+= -e 's,@QTDIR@,${QTDIR},g' post-patch: cd ${WRKSRC}/fparser && autoconf cd ${WRKSRC}/dxflib && autoconf # Just setting BUILD_DIRS would be adequate if qcad could be built with # "prepare all" in each module, one by one. But qcad needs all modules to # be prepare'd before any can be all'd, so prepare them here in a separate # loop duplicated from do-build. The unmodified do-build then takes care # of the "all". I didn't see an easier way. pre-build: ${RUN} ${_ULIMIT_CMD} \ for d in ${BUILD_DIRS}; do \ cd ${WRKSRC}; cd "$$d"; \ ${BUILD_MAKE_CMD} prepare; \ done INSTALLATION_DIRS= bin share/qcad do-install: ${INSTALL_PROGRAM} ${WRKSRC}/qcad/qcad ${DESTDIR}${PREFIX}/bin cd ${WRKSRC}/qcad && umask 022 && \ pax -rwpm data fonts patterns qm ${DESTDIR}${PREFIX}/share/qcad .include "../../x11/qt3-libs/buildlink3.mk" BUILDLINK_API_DEPENDS.qt3-libs+= qt3-libs>=3.3.4 .include "../../x11/qt3-tools/buildlink3.mk" BUILDLINK_API_DEPENDS.qt3-tools+= qt3-tools>=3.3.4 BUILDLINK_DEPMETHOD.qt3-tools= full # uses assistant for help .include "../../mk/bsd.pkg.mk"