1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
|
Converting from debstd to debhelper:
-----------------------------------
Debhelper is designed to be mostly backwards compatible to debstd. I say
mostly because I haven't made debhelper handle everything that debstd does
yet, and in a few cases, debhelper does things differently (and I hope,
better).
In general, you can switch over to using debhelper as follows. In your
debian/rules, you currently will have some lines that read something like
this:
debstd CHANGES TODO README
dpkg-gencontrol
dpkg --build debian/tmp ..
Debhelper comes with a command called dh_debstd that mimics the behavior of
debstd, by calling various debhelper commands. So in the root directory of
your package you are converting, run:
dh_debstd CHANGES TODO README --verbose --no-act
Notice the parallel to the debstd command above, I just added "--verbose --act"
to the end. This will make dh_debstd output a list of commands that it thinks
will emulate what debstd would have done, without actually doing anything to
your package. The list will look similar to this:
dh_installdirs
dh_installdocs TODO README
dh_installexamples
dh_installchangelogs CHANGES
dh_installmenu
dh_installcron
dh_installmanpages
dh_movefiles
dh_strip
dh_compress
dh_fixperms
dh_suidregister
dh_shlibdeps
dh_gencontrol
dh_makeshlibs
dh_installdeb
dh_md5sums
dh_builddeb
Now copy that output into debian/rules, replacing the debstd command, as
well as any dpkg-gencontol and dpkg --build commands.
Finally, debstd automatically modified postinst, postrm, etc scripts. Some
of the debhelper apps do that too, but they do it differently. Debstd just
appends its commands to the end of the script. Debhelper requires that you
insert a tag into your scripts, that will tell debhelper where to insert
commands. So if you have postinst, postrm, etc scripts, add a line reading
"#DEBHELPER#" to the end of them.
Once you think it's all set up properly, do a test build of your package. If
it works ok, I recommend that you compare the new package and the old
debstd-generated package very closely. Pay special attention to the
postinst, postrm, etc scripts, and make sure that the new package contains
all the same files as the old, with the same permissions.
-- Joey Hess <joeyh@master.debian.org>
|
